CUSTOM AIRCRAFT DESIGN REQUIREMENTS & INFORMATION

 

 

PATTERN QUALITY;

You must provide us with a very accurate pattern made of poster board or paper, or send us your actual instrument panel if it is removable.   We will duplicate your pattern.   However if your pattern is not a good fit, then the panel we make for you will not fit either.

 

HOW BIG CAN MY DESIGN BE?

The sheet of raw material that we use is 24”x48”.   Therefore any part you want made must fit within these dimensions.

 

DESIGN LIMITATION:

Our finished product is made to be flexible in any one direction but does have limitation from contouring to a part in all directions.   Please consider this when sending us a custom design since we are not responsible if your design fails to contour to the part that is to be covered.   (Try to design parts that are flat)

 

HOW DOES IT ATTACH?

Once you kit is manufactured it comes ready to install by means of super duty double sided bonding tape already attached to the material of your choice.  You simply clean your panel with alcohol, apply a supplied primer, peel the double sided tape liner and press over receiving area on your panel.  If you supply us with the actual panel we will install your custom piece for you at no additional charge.

 

HOW LONG DOES IT TAKE?

Since our volume for custom design requests fluctuates, we ask that you allow up to three weeks for your design to be completed.   Custom designs are on a first-come first-serve basis.

 

HOW MUCH DOES IT COST?

We offer three types of material, standard, premium and designer. 

If you choose standard material your cost per square inch is $0.95. 

If you choose premium material your cost per square inch is $1.20. 

If you choose designer material your cost per square inch is $1.30.

If you need 1/8” stiffening backer add $0.05 per square inch.

If you need ¼” stiffening backer add $0.10 per square inch.

If you need lettering add $3.00 per word.

 

QUOTE:

Once we receive your pattern, our Design Department will give you a free quote.   The following is a cost formula example:

 

 

 

Suppose your panel is 11” x 33”, your total square inches would be 363.

Cost on standard material would be $344.85 plus shipping.

Cost on premium material would be $435.60 plus shipping.

Cost on designer material would be $471.90 plus shipping.

1/8”backer for this size panel if needed would be $18.15.

¼” backer for this size panel if needed would be $36.30

The cost of the one word on this panel would be $3.00

 

 

6500 47th Street, Unit 1, Pinellas Park, FL 33781

Tel:  727-528-4488                  Fax:  727-528-9411

                    Toll Free:  888-960-9663

 

Copyright Gemico Products 2007